22-08-2012, 10:56 PM
I added the infills to motor mount area to bring motor forward some but you not need too on your model depending on motor and shaft length.
I rehinged all my control surfaces with plastic hinges and taped along as well.
Control horns i used are the same, glued them on with hot glue / super glue both pieces.
Used z pliers to adjust my servo rods as i glued my horns on in the wrong position. ( Build Note )
Do you have landing gear with it ?
If so use cable ties supplied with the two pieces of ply on top and underside and weave cables through and tighten landing gear rod to it.
Steve
I rehinged all my control surfaces with plastic hinges and taped along as well.
Control horns i used are the same, glued them on with hot glue / super glue both pieces.
Used z pliers to adjust my servo rods as i glued my horns on in the wrong position. ( Build Note )
Do you have landing gear with it ?
If so use cable ties supplied with the two pieces of ply on top and underside and weave cables through and tighten landing gear rod to it.
Steve
What Do You Mean Theres a Throttle Curve ?, Its Either all the way up or all the way down