09-05-2012, 08:58 PM
Hi guys,
I got a small problem installing the motor in my HET flying wing. As can be seen the front of the fuselage/pod is not straight.
One side is considerably thicker than the other, and no this is NOT side thrust.
Instruction manual pic is page 6 of : http://www.modelflight.com.au/ProdInfo/F...manual.pdf
Should I sand it back to even or should I fill out the shallow end? Either way I think it would look messy....
BTW, wings and ailerons/elevons fitted together just fine, seemed like a simple build till this....
I got a small problem installing the motor in my HET flying wing. As can be seen the front of the fuselage/pod is not straight.
One side is considerably thicker than the other, and no this is NOT side thrust.
Instruction manual pic is page 6 of : http://www.modelflight.com.au/ProdInfo/F...manual.pdf
Should I sand it back to even or should I fill out the shallow end? Either way I think it would look messy....
BTW, wings and ailerons/elevons fitted together just fine, seemed like a simple build till this....