[robair]

Mornin All

I have a couple of q's. Can anyone recommend a good high speed mg digital servo to run the swash in my my new HK 500? Goteck gd9257's prev fulfilled the role however one stripped its guts out when my old 500 killed itself. So need 3 new ones. Don't wish to break the bank however don't want to skimp either.
Also, my viper jet runs digital servos all round except for the servo that runs the air retract valve, it is analogue. Is that servo going to have issues if I set my tx to 11ms digital frame rate?

Finally, Frank your rx issue is very odd, the variable flash speed is something I have not seen before. The rx usually flashes fast when binding and slow if signal/ power lost? Think you may have a tx problem, they haven't upgraded it to DSMX or something like that have they?

Cheers
Rob B