18-01-2012, 12:25 PM
RX Switch - Safety Isolation between Pitts and runway.
As my planes are getting bigger, it's becoming cumbersome and awkward carrying the plane back to the pitts with it still powered on. Already had one close incident where my hanging TX knocked on my body moving the throttle stick and nearly slicing my nose off with the spinning prop.
Are these switches simply inserted between the lead from the ESC to the RX??
http://www.hobbyking.com/hobbyking/store...Blank.html
http://www.hobbyking.com/hobbyking/store...witch.html
Or is there a simpler way to handle this???
As my planes are getting bigger, it's becoming cumbersome and awkward carrying the plane back to the pitts with it still powered on. Already had one close incident where my hanging TX knocked on my body moving the throttle stick and nearly slicing my nose off with the spinning prop.
Are these switches simply inserted between the lead from the ESC to the RX??
http://www.hobbyking.com/hobbyking/store...Blank.html
http://www.hobbyking.com/hobbyking/store...witch.html
Or is there a simpler way to handle this???
Dynam Pitts 12 EPO
Eflite Advance 25e
HK P-51D Mustang
3D Reaktor
Pitts Python S12 EP 54inch EPO
Kinetic 800
Decathlon EP 62.6inch
Stinger 64 EDF
Spektrum DX6i (mode 1)