28-08-2016, 08:28 PM
I managed to get my Eachine 250 cc3d board to load CleanFLight firmware.
I first used an older Cleanflight version .bin file to reprogram the board to Cleanflight,
(hoping it would then allow me to update to 1.13 -Fat Hope- )
Ended up using Cleanflight firmware upgrade and an FTDI like serial programmer to load the latest cleanflight .hex (1.13)
It's working to the point were the serial receiver is responding (Lemon satellite in Uart 1)
Still need to work out the other settings (PID, Motor mapping etc )
Would anyone have a cleanflight base setting for the eachine 250 ?
Cheers,
Dirk.
I first used an older Cleanflight version .bin file to reprogram the board to Cleanflight,
(hoping it would then allow me to update to 1.13 -Fat Hope- )
Ended up using Cleanflight firmware upgrade and an FTDI like serial programmer to load the latest cleanflight .hex (1.13)
It's working to the point were the serial receiver is responding (Lemon satellite in Uart 1)
Still need to work out the other settings (PID, Motor mapping etc )
Would anyone have a cleanflight base setting for the eachine 250 ?
Cheers,
Dirk.
If you don't live on the edge, you take up too much space.