21-11-2014, 07:58 PM
Just to keep this topic in the appropriate thread (something we should all do).
My new PA Extra MX likes to roll dramatically when I try to loop (& for the life of me I cannot remember which way). Jason had suggested I check the lateral balance. Have just done so but all it needed was 5 cents taped to the outside of the right wing.
I have also previously mentioned that when I glued the Horizontal Stab into the fuse, the glue cured in a manner that caused it to minimally not be horizontally parallel to the main wing.
Measured by "eye" only, there does not appear to be any warping in the horizontal stab or elevator.
Maybe I will have to do an elevator rudder mix, but will need some programming help.
Anything I may have missed to check?
My new PA Extra MX likes to roll dramatically when I try to loop (& for the life of me I cannot remember which way). Jason had suggested I check the lateral balance. Have just done so but all it needed was 5 cents taped to the outside of the right wing.
I have also previously mentioned that when I glued the Horizontal Stab into the fuse, the glue cured in a manner that caused it to minimally not be horizontally parallel to the main wing.
Measured by "eye" only, there does not appear to be any warping in the horizontal stab or elevator.
Maybe I will have to do an elevator rudder mix, but will need some programming help.
Anything I may have missed to check?