17-05-2011, 06:19 PM
Could be Bearing issue,
Common Causes are -
1. Prop Adaptors bent and not fitting on shaft straight.
2. Prop adaptor itself
3. Props are not always what they seem, they may be fine up to half throttle but when you give it goes way out of balance.
( i went through about 3 to get a good one)
4. Shafts not straight
Steve
Common Causes are -
1. Prop Adaptors bent and not fitting on shaft straight.
2. Prop adaptor itself
3. Props are not always what they seem, they may be fine up to half throttle but when you give it goes way out of balance.
( i went through about 3 to get a good one)
4. Shafts not straight
Steve
What Do You Mean Theres a Throttle Curve ?, Its Either all the way up or all the way down
